Nx-4v2 user manual

Apply power to the control panel. The GE Caddx Networx line of security systems offer many of the features of more complicated alarms, but at very reasonable prices. The largest panel is the Caddx NX-8, with 8-zones on-board, expandable to.

Align the bottom of the circuit board in the edge guide standoff and twist the st andoff into place Figure 4. Tighten the mounting screw Figure 2. User Code A four 4 or six 6 digit entry code used to arm or disarm the system.

Page Emergency Activation Keys The security system will not arm if the ready light is not on or flashing. Restore power if possible. If not, contact your installing company for service. Note: The abort feature must be enabled. If the chime is on, the chime light will be illuminated. If the chime is off, the chime light will be off.

Press the [ ] key while the ready light is flashing to exit the User Code Programming Mode. Page Assigning User Code Authority Levels - 6 until you have assigned authority levels to all user numbers. Press the [ ] key to exit the Assigning Authority Level Program. Page 16 ]-[7].

Resets have now been performed. If the keypad begins beeping, the reset did not execute properly. Warning devices w ill need to be loud enough, w ired correctly, and properly placed. Your periodic test should be done w ith A. Pow er removed to verify the battery is connected and adequately charged. Transformer after testing. Armed Light Bypass Light Cancel Light Chime Light Exit Light Fire Light Instant Light Power Light Ready Light Stay Light Zone Light Using The Quick Arm Disarming The System Bypassing Zones Group Bypass Setting The Keypad Tone Change Partition View Alarm Memory Test Function